Implementation of an Intelligent System for Cleaning Photovoltaic Modules, Including a System for Recycling Used Water
Hamidou Dit Togoudogoly Sagara *
Laboratory of Optics, Spectroscopy and Atmospheric Sciences (LOSSA), Center of Excellence in Photovoltaic Solar Energy (CESP), Institute of Applied Sciences (ISA), University of Sciences, Techniques and Technologies of Bamako (USTTB), Bamako, Mali.
Thierno Madani Sidibe
Hybrid Renewable Energies Laboratory (HREL), Faculty of Sciences and Techniques of Bamako (FST), University of Sciences, Techniques and Technologies of Bamako (USTTB), Bamako, Mali.
Cheick Oumar Kindo
Laboratory of Optics, Spectroscopy and Atmospheric Sciences (LOSSA), Center of Excellence in Photovoltaic Solar Energy (CESP), Institute of Applied Sciences (ISA), University of Sciences, Techniques and Technologies of Bamako (USTTB), Bamako, Mali.
Demba Sow
Laboratory of Optics, Spectroscopy and Atmospheric Sciences (LOSSA), Department of Electrical Engineering and Industrial Computing (GEII), Institute of Applied Sciences (ISA), University of Sciences, Techniques and Technologies of Bamako (USTTB), Bamako, Mali.
Diakalia Kone
Laboratory of Optics, Spectroscopy and Atmospheric Sciences (LOSSA), Department of Electrical Engineering and Industrial Computing (GEII), Institute of Applied Sciences (ISA), University of Sciences, Techniques and Technologies of Bamako (USTTB), Bamako, Mali.
Abdoul-Wahidou Mahamadou
Modern Workshop for Adapted Technologies (AMTA), Bamako, Mali.
Siriki Konate
Modern Workshop for Adapted Technologies (AMTA), Bamako, Mali.
*Author to whom correspondence should be addressed.
Abstract
Dust accumulation on photovoltaic modules can reduce their electrical output and increase the need for periodic cleaning, particularly in dry environments where water availability is limited. This study developed and tested a prototype automated photovoltaic-module cleaning system incorporating mechanical cleaning, electronic control, and recovery and filtration of used washing water. The system was built around an Arduino Mega 2560 controller and included motors, pumps, solenoid valves, limit switches, water-level sensors, a keypad, and an LCD interface. Automatic and manual operating modes were implemented together with a water-recycling circuit using recovery, sedimentation, and filtration stages. Prototype tests compared electrical measurements obtained from clean and dust-covered photovoltaic-module conditions and evaluated water recovery during successive cleaning cycles. The experimental measurements showed an average open-circuit voltage difference of 15.7% between the compared clean and dusty conditions and an average voltage difference of 24.6% under load. In the before-and-after washing tests, measured power increased from 7.24 W to 9.92 W under the reported experimental conditions. The water-recycling tests produced an average recovery rate of 89.96%. These results demonstrate the technical feasibility of combining automated module cleaning with recovery of cleaning water in a single prototype. Further testing under controlled and repeated environmental conditions is required to quantify its long-term electrical, hydraulic, and economic performance.
Keywords: Automatic cleaning, solar modules, water recycling, Arduino Mega 2560, energy efficiency, maintenance